C2 VoLTE provider support

General
#11

What is the expected state of 4g mobile data? It is not included in the table for obvious reason but it does not work in my case.

#12
Country Provider Registered Voice in Voice out SMS in SMS out MMS in MMS out Compared
UK GiffGaff ✓ ✓ ✓ ✓ ✓ ? x ✓

I’ve compared it with 10iii, (it seems VoLTE on 10iii cannot send out sms). Sending out an MMS on C2 has failed with “Problem with sending message”.

#13

4g mobile data should work, if it doesn’t work on some network logs might be helpful.

#14

Worked for me on a second try. Is this a repeat attempt or “just” once? (tbf, it’d be nice if it retried automatically once or twice if it failed the first time).

#16

on 10iii I had to switch to 3G to send out an sms, C2 can receive and send sms on 4G (VoLTE) with no issues. C2 failed to send an MMS, I did try twice.

#17

Installed as described, inserted SIM into slot 2 and tryied SMS, MMS, call, hotspot. Everything worked, I can browse during the call, I can have hotspot during the call. Status 4G all the time.

Country Provider Registered Voice in Voice out SMS in SMS out MMS in MMS out Compared
SI Telekom ✓ ✓ ✓ ✓ ✓ ✓ ✓ ?

BUT! After short time (about 30 minutes) of testing, problems started. In that moment, I had SIM in slot 1. Photo via MMS not received (spinnig icon), but received when mobile data become disabled. Suddenly, cellular netwok settings removed. Finally, SIM is not recognized anymore in any slot. Utility to restart network subsytem does not help.

I think that VOLTE is implemented nicely, because it worked OK until something else broke. I observed similar situation (SIM not recognized after some time) also before, when I tryied SIM after initial setup (version 21, no VOLTE).

1 Like
#18

I had no 4g data just after installation of volte packages but I left the phone for some time and it worked. I cannot reproduce this problem, maybe it was something network related.

#19

Ok, good to hear. Please report if you have issues with mobile data later.

1 Like
#20

For now it seems that A1 is still the only network that doesn’t register. I sended the logs. I hope that it’s enough. If not just ping me.

#21

@filip.k Could you verify that you have that ofono-vendor-unisoc-radio-plugin package installed?

#22

From my list it seems that I do.
I seem that Xperia 10 III had serious troubles on A1 network too. That’s from another tester.

I can revert and reinstall or do you have better suggestion?

Edit:

Install printout from ssh (in Slovene)

[root@JollaC2 defaultuser]# pkcon install ofono-vendor-unisoc-radio-plugin ofono-binder-plugin libofonobinderpluginext
Razreševanje
Preizkušanje sprememb
Končano [ ] (0%)
Namestiti je treba naslednje pakete:
libofonobinderpluginext-1.1.18-1.10.1.jolla.aarch64 Extension framework for ofono-binder-plugin
ofono-binder-plugin-1.1.18-1.10.1.jolla.aarch64 Binder based ofono plugin
ofono-vendor-unisoc-radio-plugin-1.0.0-1.1.1.jolla.aarch64 UNISOC radio extension
Ali želite nadaljevati s spremembami? [N/y] y

Preizkušanje sprememb
Nameščanje
Začenjanje
Nameščanje paketov
Prejemanje paketov
Nameščanje paketov
Končano
[root@JollaC2 defaultuser]#

#23
Country Provider Registered Voice in Voice out SMS in SMS out MMS in MMS out Compared
HU / Hungary Telekom ✓ ✓ ✓ ✓ ✓ ? ✓ ?

Unfortunately, there is often no ringing or vibration for incoming calls. The mobile internet also often goes down, but the 4G label is there next to the network signal. I will also test the Vodafone network soon.

#24

Sailfish OS version: 5.0.0.29
SIM provider and country: Tele2, SE
Network provider and country (if roaming): n/a
Number of SIM cards in use and in which slot: 1 / 1

Country Provider Registered Voice in Voice out SMS in SMS out MMS in MMS out Compared
SE Tele2 ✓ ✓ ✓ ✓ ✓ ✓* ✓* ?

* Outgoing MMS was stuck on Sending..., incoming MMS was stuck on Waiting... until I disabled mobile data. Then both worked within seconds. Previously reported by meolic above.

Will be away/busy, but will try testing while roaming.

#25

All working on Fello (Telia) SE. I even had ringback tone on VoLTE - wow!

2 Likes
#26

Tried roaming with VoLTE without success. Will provide logs by PM.

Edit: Logs sent and table in OP updated

#27

You could share a picture from a gallery to Messages and send it to yourself, would that work?

Could you provide mcc and mnc values used? What operator name is displayed in lock screen, and is it the correct one?

@Dr.Recor I added your results to the opening post – now all results listed in replies up to this point are there as they should.

1 Like
#28

@direc85: Any task for us without even registration?

#29

We’re looking into more specific logging instructions still.

2 Likes
#30

So my current logs are useless?

#31

I was referring to the more detailed and focused logging instructions, so that less “excess” information is saved. The ofono logs are rather verbose, let’s put it that way.

1 Like